Qslip - User Guide - Set Layout Positions
Grab a ruler and a blank pre-printed deposit slip
- For best results, make all measurements to the nearest 32nd of an inch.
- Skip any items not used on your slip format (eg. Checks Total) -- they will appear grayed-out.
- You may enter decimal or fractional amounts in the measurement edit controls (decimals will be converted to the nearest fraction).
|
|
1. Set the value for "Number of Checks" to the exact number of check lines on the front of the deposit slip.
2. Measure the overall width and height of the slip, and enter values in "Slip Width" and "Height."
3. Measuring from the left edge of the slip, to the points marked in blue, enter the corresponding values.
4. Measuring from the top edge of the slip, to the points marked in red, enter the corresponding values.
|
|
5. Measuring from the left edge of the slip, to the points marked in blue, enter the corresponding values.
6. Measuring from the top edge of the slip, to the points marked in red, enter the corresponding values.
|
If the format is 2-sided:
|
7. Set the value for "Max Checks" to the exact number of check lines on the back of the deposit slip.
8. Measuring from the left edge of the slip, to the points marked in blue, enter the corresponding values.
9. Measuring from the top edge of the slip, to the points marked in red, enter the corresponding values.
|
If the format is Multi-Columned:
|
Follow the special instructions. This feature is primarily included in order to print to the QB native format, however it can be used to print to other multi-columned slips.
|
|
